“We have the Honeywell air purifier. We just changed all the filters & the “check pre-filter” light is on. Any ideas?”

1-5 of 5 Answers

• Just pressing and holding the OK button did not work for me ..i had to hold it while unit was off, then pressed power on while also pressing OK...tah-dah!

  Answered by Anonymous 3 years ago

  • 

  Helpful (14)Unhelpful (3)

  Report

  Sorry, there was a problem. Please try again later.

• Thank you for your inquiry. The "Check Filter" lights are a timer that will turn on to let you know when you should replace your filters. Once the filters have been replaced, select the highest speed and press and hold down on the "Check Filter" button for around ten seconds, or until the light turns off. This will reset the "Check Filter" light. If you have any other questions please do not hesitate to contact our consumer relations team by emailing us at [email protected]. Thank you.

  Answered by ManufacturerTechSupport 6 years ago

  Helpful (25)Unhelpful (26)

  Report

  Sorry, there was a problem. Please try again later.

• Reset filter lite,it went off.it came back again

  Answered by Danamo 4 years ago

  Helpful (1)Unhelpful (4)

  Report

  Sorry, there was a problem. Please try again later.

• I have tried all. Light on still. 3 rd change

  Answered by Anonymous 2 years ago

  Helpful (0)Unhelpful (4)

  Report

  Sorry, there was a problem. Please try again later.

• Press and hold the check prefilter button for at least 3 seconds. It will go off.

  Answered by trainguy 5 years ago

  • Verified Purchase
  • 

  Helpful (3)Unhelpful (33)

  Report

  Sorry, there was a problem. Please try again later.