“Why doesn’t my machine pickup the water right away when I pull it back? It always leaves dirty water on the floor when the clean water starts to get low. My machine is new, only used it a couple of time..”
Answer This Question
1-2 of 2 Answers
While the FloorMate Jet constantly suctions up the water, a lot of water can be difficult to pick up in one pass. We recommend passing over the area as needed without using the solution trigger to suction up all the access water. If you have any further question we would be happy to help, please reach out to us at Hoovercommunity@ttifloorcare.com. Thanks, Joseph - The Hoover Team
Sorry, there was a problem. Please try again later.I found that I was spraying way too much solution. Now I use the spray sparingly unless I have a very dirty spot, in that case I do put more solution down. Since I've started doing this I haven't had any more issues such as this. There was one time when I didn't seat the brush roll properly and it was not spinning. This also caused the dirty solution to be left on the floor. Other than these two issues I've not had a problem at all with it leaving dirty solution on the floor.
Sorry, there was a problem. Please try again later.
