“I have a MR8300 router and purchased three nodes WHW0303 Velop Nodes that are used. So because they were setup on another system by someone else do I just do a reset on the used nodes then linked them as if they are new? any suggestions?”

1-2 of 2 Answers

• Hi there. Resetting the existing tri-band nodes would be essential so you can reconfigure them with the MR8300 router (should act as the parent node). Please reach out to us at [email protected] along with your contact details and link to this post so we can lend you a hand further.

  Answered by Linksys Staff 5 years ago

  Helpful (2)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Yes reset them and use them as if they are new. It will make your life a lot easier. To reset hold the reset button on the bottom until the flashing red light fades away.

  Answered by klinear 5 years ago

  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.