A:AnswerOnce you remove the top of the stove, the panel can be removed from the inside. You were lucky to get 5 years out of this unit, ours fried out after 3 weeks of light use.
A:AnswerYou are correct that the bottom of the lip needs to rest on the countertop. The legs are adjustable, but the lowest they will go requires a countertop height of 35-3/4". I've had the same issue myself on a couple of houses (I'm a builder) and here are a couple of fixes I've used.
1) The legs are a nylon material with a spiral groove around the perimeter that allows it to turn clockwise into the base of the range. Using an angle grinder I was able to extend the length of the groove so that the leg would turn further into the base. This provides approximately an additional 1/4"-3/8" of height reduction.
2) Remove the finish flooring where the range sits. This is a pretty simple fix and, depending on the thickness of your finish flooring, (which is generally between 3/8" to 3/4") might be enough to do the trick. If not, you'll have to use both methods. Be sure to cut the flooring just in front of where the front legs sit so that it is concealed when the range is installed. A variation on this would be to use a hole saw or spade bit to cut out holes in the finish flooring only in the area where the legs rest on the floor.
Hope this helps. This is a very nice range so in my opinion it's worth the extra effort, though I wish they would just redesign the legs to accommodate lower countertops.
A:Answer120 AC. A standard 3 prong plug. If you are installing yourself and your not roughed in get a copy of the stove specs. The gas and the electrical rough in low to the floor. This needs to be done crrectly so the stove can slide all the way to the back wall
A:AnswerHello jimbo! According to our specifications site (https://bit.ly/2OdDJjm) the range's height can be adjusted from 36" 3/16 to 37 3/16". ^Jecca
A:AnswerHi Baker! I'd like to try and help with this. Look over this link (https://bit.ly/2qw3Zbf) for some information on possible causes of the control panel not responding. ^Jecca
A:AnswerYep, ended up setting for 9hr 99min. Still disappointed because this seems to be due to oversight on design of the interface so that somebody could make it look pretty. Plenty of room to add another digit to the hours.
A:AnswerThe front right burner is 2 stage. 1st stage is surface of the Sun hot. 2 quarts water boil in 4-5 minutes. Second stage is just the center ring for simmer
