I just purchased the 9200S rear speakers to work with my Samsung 600B soundbar. They paired but can't get much sound out of them, despite the rear ch. set on +6 on is quite low, surround sound on, etc. Hate to return them, but... null

Question

TnTMDB · Accepted Answer

I have the same issue with them and the same soundbar.

Samsung · Answer

Hello Vernon1,

By design, the surround speakers are supposed to simulate sounds happening behind the viewer.  Therefore, most of the time the surround channels are only used for ambient sounds, which are naturally lower in volume.

However, there are a few settings you can change to adjust the surround effect to your preference:

Make sure that the source (e.g. TV output) is sending surround channels to the Soundbar.  If the source is not capable of surround, then set the Surround mode to OFF on the Soundbar by pressing the Surround button on the remote.

Turn off Dynamic Range Control.  This is done by pressing and holding the Sound Mode button while the Soundbar is in standby mode.  Depending on your soundbar model, you may or may not have DRC.
~Samsung Solutions

“I just purchased the 9200S rear speakers to work with my Samsung 600B soundbar. They paired but can't get much sound out of them, despite the rear ch. set on +6 on is quite low, surround sound on, etc. Hate to return them, but...”

1-2 of 2 Answers