“Hello, my shark robot shows Empty reservoir when i try to mop, the water containers has been cleaned and filled with water and solution, it doesnt matter what i do,i cant remove the empty reservoir error Any suggestions Please and thank you”
Answer This Question
1-2 of 2 Answers
Since it's apparent the Shark folks aren't going to help with a comment (phone number is great, but what about after hours or on a Sunday?), I'll share what's worked for me. Anyway, if it's a sensor issue, then not sure what to tell you, but here's what has worked for me: (1) there are three(?) pipes on the front end of the tank. When you have the tank removed and you're looking at the part/end that connects to the vacuum (the front of the tank), the pipes/tubes are on the Left side. I get a toothpick and gently poke all three, but I suspect the culprit is the Right-hand one because it has a check valve, and I depress the valve, causing a 1/16 of a tsp to leak out. I suspect this is sticking. (2) I think it is sticking because I HAD been using 100% fluid. I now mix some water in with the fluid, so 50/50 mix. And that is very "about" because I add one to the tank and then the other, so it would be 30/70, dunno, but as long as there's some, or even a bunch of water because it think the solution/fluid is a bit thicker/stickier than water, so I want to thin it out to keep the check-valve from sticking. Conclusion, I may be 100% wrong in my "fix," but it's worked for me.
Sorry, there was a problem. Please try again later.We're sorry to hear your robot isn't working as intended. To assist you with this, please reach out to our phone support at 888-228-5531. We're available Mon.-Fri. 9 a.m.- 9 p.m. ET, Sat. 9 a.m.-6 p.m. ET. When you reach out, ensure you have your robot with you.
Sorry, there was a problem. Please try again later.
