“The mounting plate has 2 tabs that protudes above the rest of the mounting plate. Are they to be tight up against the bottom of the cabinet or are they to be bent down into the slots and then the mounting plate be pushed up to the bottom of the cabinet?”
Answer This Question
1-5 of 5 Answers
My microwave does not sit on the bracket will this cause a problem
Sorry, there was a problem. Please try again later.The 2 up tabs are meant to be bent down. Use these tabs/holes if you have to use the 2 toggle bolts provided. Then make sure to mount bracket at least within 1/8 of the bottom of the cabinet and centered. Make an effort to find a stud or 2 to mount the bracket to. I use some the extra screws drilled into the holes provided for more support. Use a partner to hold up the unit, approximate where the bolt holes should be drilled in the bottom of the cabinet. The 2 long bolts/screws with large flat washers will come down thru the bottom of the cabinet into the 2 slots near the top front of the microwave. DO NOT over tighten these 2 bolts. The protruding lips on the bracket is what the back of the microwave sit on.
Sorry, there was a problem. Please try again later.the two tabs that extend past the edge of the bracket are to be bent in after using them to show where to drill the holes for mounting under the cabinet.
Sorry, there was a problem. Please try again later.Hi Jane, you would need to bend the tabs into the down position.
Sorry, there was a problem. Please try again later.The tabs can be bent down.
Sorry, there was a problem. Please try again later.