How can I get a template for rear through the wall vent cutout (3.25”x10”)? It’s not integrated into the all in one metal template that’s included. null

Question

RPC53 · Accepted Answer

One way to do this is to put the unit on a table and sit the mounting bracket on the top as though it was mounted and hanging in place and tape it down. Then you can mount the damper to the rear of the unit as though it was in place on the wall and take actual measurements for the venting position. The mounting bracket fits nice and tight to the top of the unit so your measurements should be good. If venting through the back, make sure there is no wall stud where the vent will exit through the wall. If there is then you'll have to vent into the filter and not to the outside.

Answered by RPC53 7 years ago

Verified Purchase

Kiki · Answer

It came with the microwave, but I used YouTube. You Tube was extremely helpful, I just put the microwave information and I got step by step instructions.

“How can I get a template for rear through the wall vent cutout (3.25”x10”)? It’s not integrated into the all in one metal template that’s included.”

1-2 of 2 Answers