Cable Leader - Power Extension Cord, IEC C13 to C14 Fully Molded, 18 AWG 10A 250V for PDU, UPS, Monitor, Desktop PC - Red

Add Reach Without Rewiring - C14 Male to C13 Female

Drop this power cord extension between the outlet strip and the gear instead of pulling a whole new run. The C14 male end goes into a spare C13 outlet on a PDU, UPS or surge strip; the C13 female end goes onto the equipment inlet. Lengths from 1 to 25 ft cover the short hop between adjacent rack units and the long reach to a desk or wall strip, and it works as a power cord extender or a replacement when the original is lost or damaged.

10A 250V on 18 AWG Copper - UL Listed, 105C SJT Jacket

Undersized cordage runs hot and drops voltage under load. This power extension cable uses three 18 AWG copper conductors inside a flexible SJT thermoplastic jacket rated to 105C, carrying 10A at 250V - the same rating supplied with most C14-inlet equipment, so it swaps in without derating the circuit. UL Listed. Meets RoHS and REACH material requirements.

Fits Any C14 Inlet - Not for Wall Outlets or C19/C20 Gear

Six Jacket Colors - Built for A/B Feed Identification

Available in black, red, blue, white, green and yellow so redundant A-side and B-side feeds can be told apart at the back of a rack without tracing a cable by hand. Fully molded connectors and integral strain relief resist cracking where the cord meets the plug, and the SJT jacket stays flexible in cable arms and tight bends. 18 AWG three-conductor copper throughout, indoor rated for racks, data centers, offices and workstations.

Sample-Tested Production - Cable Leader Direct Support

Each production run is sample-tested for continuity, polarity and current rating before it ships. Manufactured to RoHS environmental standards. If your cord arrives defective or stops working in normal use, Cable Leader handles the replacement request directly - no manufacturer redirects.