Directed Electronics - Wiring Harness for Select Lexus and Toyota Vehicles - Black

Upgrading your car audio with an aftermarket touchscreen can quickly become a complicated mess of tangled wires. The iDatalink Maestro ACC-HU-JEN1 head-unit adapter changes that by eliminating the stressful, time-consuming task of matching, stripping, and crimping dozens of tiny radio wires together. Designed specifically for DIYers and professional installers alike, this harness bridges the gap between your new stereo and your vehicle's dash architecture in seconds. This adapter takes the place of the standard wire harness packaged with your new receiver. It features a dedicated 20-pin Jensen connector on one end that plugs directly into the back of your radio, and a 20-pin iDatalink Maestro connector on the other end that locks seamlessly into a compatible, vehicle-specific Maestro T-harness. By removing the need to splice or solder wires, it guarantees a clean installation while preventing common wiring mistakes that can lead to blown fuses or audio dropouts.

Easily replace the factory radio in your Toyota, Lexus, or Scion vehicle with this all-in-one Radio Replacement and Steering Wheel Control Interface by PAC. The RP4.2-TY11 interface comes pre-loaded with amplifier retention and steering wheel control software, navigation-based output signals and more to help simplify aftermarket radio installation while retaining your vehicle’s factory features. This radio replacement and steering wheel control interface includes wired outputs for navigation radio installation and is direct USB updatable.

Add an amplifier to nearly any radio with the KISLOC2 Stereo Line-Out Converter. Experience true sonic accuracy at any volume level with all the sparkling highs and thunderous lows of your original audio. KISLOC2 Stereo Line-Output Converter Unlike traditional LOCs the KISLOC2 is designed without inductors to deliver a completely flat frequency response at all volume levels. Using nothing more than your factory speaker wires the innovative KISLOC2 automatically converts the speaker signal into both an RCA signal and a powerful 100 milli-amp 12-volt remote wire using DC offset. Powerful enough to turn on multiple amplifiers the 12-volt remote wire delivers plenty of power without hunting for a switched 12-volt power source. Accepts up to 55 watts (16 volts) of input signal Fully compatible with standard radios and most smart radios* Delivers up to an 8-volt output signal Flat 20Hz-20kHz frequency range at all volume levels Includes a powerful 100 milli-amp remote turn-on wire. No 12V power source needed! LED indicator for DC offset turn-on *Amplifier output of smart radio must have 60 impedance or lower. What's in the Box 46KISLOC2 line output converter Owner's manual Specifications Accepts up to 55 watts (16 volts) of input signal Fully compatible with standard radios and most smart radios* Delivers up to an 8-volt output signal Flat 20Hz-20kHz frequency range at all volume levels Includes a powerful 100 milli-amp remote turn-on wire. No 12V power source needed! LED indicator for DC offset turn-on