Customer Ratings & Reviews

At first I wasn't sure how was going to look installation was very easy and it makes my excursion look very nice very happy with the product and it was in stock when I needed it and nobody else had it

First time I've ever used an ISO mount kit for a din and a 1/2 Ford stereo opening. My double din Sony fit perfectly after this install. Very happy.

If you are looking to give your Ford an updated and professionally installed look this product is a MUST HAVE!

I had a touch screen radio professionally installed and was amazed at how clean the look was. The dash kit was perfect!

Product was easy and directions were straight forward for installing a touchscreen head unit in a 2007 ford e450. Minor trimming needed of factory dash to fit.

The install kit attached easily with the screws included with the stereo and looks like a factory install

Worked perfect for the double DIN stereo installed in my fiancés Grand Marquis.

Perfect fit for my KIA when I upgraded the radio speakers. Everything fit correctly, no rattles! Made the upgrade easy! I always trust Metra.

Easy to use, fits for what it's meant for. Looks clean and is not expensive.

Perfect fit easy to install and looks factory replacement

This is a great installation kit and worked flawlessly. I have a 2003 Ford F-250 and with minor dash modifications, the dash kit worked great. The dash modifications is only due to the truck model and nothing to do with the install kit. Once you screw the side mounts in, the radio slid right in and locked into place. I am very pleased with this product.

This kit fit into my truck perfectly and allowed me to economically have a nice aftermarket stereo installed in my vehicle. The installer assured me that this kit would do the job and it did and I like the way the new stereo looks inside my dash.

Three piece install kit...can't be any easier. Install two pieces on SIDS and snap third piece on bottom. On a Ford Escape, you'll need to cut off the top of the dash plastic. I simply placed the radio on the bottom and then lined up and made a Mark with a pen on the top, then cut with a utility knife...your vehicle may be different. One warning...line the sides up in front before tightening the screw because if you tighten them and then push it into the dash, the front parts may not be even with the dash bezel, and it's very difficult to remove once installed!

This perfectly matches the look of the old in dash unit. Very happy with final installation. This looks like it could have come factory original.

Works as intended looks great good quality would recommend

Purchased to install a an aftermarket stereo in my ford truck . simple to use . Worked great

installation Kit fit perfectly. New stereo went right in. Looked good. Quality materials. No lose parts. tight fit, would use again on other vehicles, also would recommend.

Used this to install a pioneer touchscreen on a 2010 ford ranger. everything fits nice and tight. The side brackets force you to recess the unit a little bit farther back than I like but it still looks real good. Simple to install.

Super easy to install! The bottom pieces is really clever and glad It covers the gap

GOOD FIT AND LOOKS LIKE IT CAME WITH CAR WHEN IT WAS NEW