Customer Ratings & Reviews

This Sanus bracket goes a few steps beyond similar, cheaper brackets with a similar appearance. The Sanus difference is that it provides flexibility and access that others do not. For example, you can extend the TV out by up to 6.8 in. so that you can reach connecting cables and the release tabs should you wish to take the set down. That same extension allows more clearance for the bottom edge of the TV so that tilt can be maximized. The two scissor extenders operate independently, so there is a bit of horizontal swivel possible, too. Extending the arms when you hang the set on the mount gives you much better visibility. A screw adjustment at the top of each arm allow about a 1/2 in. of up or down travel - reassuring in case you don't install the mount perfectly level. If it you did perfectly level the mount, those adjustments allow you to fine tune the TV height (center the adjustments on their travel before you hang the TV). After the TV is hung (mine is a 55 in. Roku Plus series, with low VESA mounting holes, mounted high for bedroom use), you can slide it back and forth horizontally as required. Once your final tilt position is made, you can hand tighten each side so the TV stays at the desired angle. The instructions provided are good, if you read them carefully, except for placing the arms on the TV. The instructions aren't clear about the vertical positioning, and this could make a difference if your set's mounting holes are located low, rather than centered on your set. After a lot of thought, I believe that Sanus wants you center the arms vertically over the TV mounting holes whether the TV mounting holes are centered or low on the TV. But if the arms will then show, they want you to mount the arms higher so that the arms do not show when the set goes on the wall. Sanus does provide a height finder tool on their website that will tell you how far above the floor you should place the bracket, and it's even aware of where the holes are on a particular TV. But it can only be correct, I think, if you center the arms vertically on the holes whether the holes are centered or low on your set. In the end, I would suggest you trust, but verify, the results given by the height finder. I found that it got within about an inch of the desired height. The most difficult part of the installation may be finding your studs. My stud finder was not working reliably, so I pushed a pin with a plastic ball on its head through the dry wall on either side of center to find the edges of the studs. Sanus provides all kinds of screws, washers, and spacers, most of which you won't use, some concrete anchors, a hex wrench to make the height/leveling adjustments, and a heavy duty template that you use to determine the four drill locations. You need to provide a level, a drill, and a socket wrench. I found that if the template is level, the bracket will be also. But if not, you've got the adjustments!

This SANUS Elite mount is extremely well built and inspires confidence right out of the box. Installation is straightforward, the hardware is high quality, and the 4D tilt makes adjusting the TV smooth and precise. The ability to extend the TV for easy cable access is a huge plus, especially for larger screens. Once mounted, the TV feels secure and perfectly positioned with no sag or wobble.

Very nice mount. Easy install and it handles my 85 inch Samsung QN90F which weighs 100 lbs. with no problems. It extends out for access to all your cable inputs and swivels and tilts for a variety of angles. No regrets on this purchase!

This mount made installing a large TV a very simple experience. It includes a paper template for marking holes on your wall, and is very flexible for stud width, which helps when my wall did not have 16" o.c. studs. Once mounted on the wall, having the ability to rotate, tilt, and swing the TV out left and right makes adjusting for window glare or plugging in cables a breeze. I have already changed TVs since installing this mount, and the adjustment holes on the TV side allowed me to adjust the height of the new TV without having to move the bracket on the wall, which saved hours of work. I paired this mount with a Sinus in-wall power and cable management, which fits inside of the bracket box area, and they will likely be the only solution I will ever need in my living room.

The TV mount I recently purchased, known as the "SleekView Universal TV Mount,"has proven to be a reliable and versatile addition to my home entertainment setup. Offering both functionality and aesthetics, this mount provides a secure and space-saving solution for displaying my television. First and foremost, the build quality of the SleekView TV mount is impressive. Constructed from durable materials, it instills confidence that my television is safely supported. The mount's sturdy design ensures stability, even when adjusting the viewing angle or swivelling the TV. I appreciate the peace of mind that comes with knowing my valuable screen is securely mounted on the wall. Installation of the SleekView TV mount was straightforward and hassle-free. The package included all the necessary hardware, and the clear instructions made the process relatively simple, even for someone without extensive DIY experience. Within a short time, my TV was securely attached to the wall, allowing for a clean and clutter-free setup. The mount's versatility is another notable aspect. It accommodates a wide range of television sizes and is compatible with VESA mounting patterns, offering flexibility for different models. I found it easy to adjust the tilt and swivel angles to achieve the optimal viewing position for my preferred seating arrangement. This adaptability ensures that users can enjoy their favorite shows and movies from various angles, enhancing the overall viewing experience. In terms of aesthetics, the SleekView TV mount lives up to its name. With its slim profile and minimalistic design, it seamlessly blends with my living room decor. The low-profile mount keeps the TV close to the wall, creating a sleek and modern appearance. Additionally, the ability to conceal cables within the mount's built-in cable management system further contributes to a clean and organized look.

I recently purchased the SANUS Elite BLT3 Advanced Tilt 4D TV Wall Mount to accompany my son's new TCL Q7 Class Smart TV, and the experience has been nothing short of exceptional. Revolutionary Design: The BLT3 features a revolutionary design, providing an impressive 6.8" of extension on a tilting mount. What sets it apart is the Tilt 4D advanced technology, allowing the TV to tilt in four directions, providing improved viewing angles and making cable hookup a breeze. More Tilt, Less Glare: Unlike traditional tilting mounts that limit maximum tilt due to hitting the wall, the BLT3 solves this issue by extending from the wall. This extension not only offers a larger tilt range but also translates to better glare reduction, making it the perfect choice for above-eye-level mounting locations, such as over the fireplace. Easy Cable Hookup and Access: The 6.8" extension from the wall not only facilitates easy cable hookup but also allows quick and convenient access to cables and wires even while the TV is still mounted. This feature made the initial hook-up and future device switches a quick and hassle-free process. Effortless Adjustment and Swivel: The mount effortlessly swivels, catering to TVs of various sizes, including my son's 55-inch TCL TV. ProSet™ Technology ensures easy adjustment of the level and height of the TV after installation, providing flexibility for achieving the ideal viewing position. Thin Profile and Open Wall Plate Design: With a seamlessly thin profile of just 2.1" from the wall, the BLT3 blends seamlessly with both the TV and the room's décor. The open wall plate design allows the mount to be directly mounted over electrical outlets or media boxes, adding to the versatility of installation. Easy Installation, Even for a Solo Effort: I was pleasantly surprised by how easy it was to install the SANUS Elite BLT3. I drilled directly into the studs and managed to install the wall mount and lift the TV onto it, all on my own. As a sizeable individual, I found the process manageable, but I would recommend following the manual's advice and getting a second person for larger TVs, like my son's 55-inch TCL. Safety first! In conclusion, the SANUS Elite BLT3 Advanced Tilt 4D TV Wall Mount not only provides a secure and sleek mounting solution but also enhances the overall viewing experience. Its innovative design, easy cable hookup, and effortless adjustment options make it a standout choice for anyone looking to elevate their TV setup. I highly recommend it for a seamless and sturdy mounting experience.

[Employee of bestbuy] The large length on the bracket gives you so much room to center the mount on the wall no matter where your studs are at in most residential homes. The arms extend out to give plenty of room to plug in extra inputs or cables once the TV is already mounted on the wall. Installation is simple and easy and works with almost all TVs.

We got this for our 83" Samsung OLED. Installed quickly and works great. Easy positioning left-right and in-out from the wall with a light touch. Setting the up-down angle required more pressure but that was a one-time adjustment to get it aimed at seated eye-level. Since the TV has an OLED screen (which produces an excellent picture at ultra-wide viewing angles) we only needed a slight left-right angle, so this mount's 6.8" max extension from the wall is perfect for our TV. If you need more extreme left-right adjustment (as with an LED screen and variable viewing angles) you can get the more expensive model that extends out 20" from the wall. There's also a less expensive fixed-position model. But for our setup, with a large OLED screen, this mount fit the need perfectly.

Bought this to hang my new 65” inch Samsung tv in living room wall. So very to install that it didn’t really require me to look at the instructions. It took about 15 minutes to put together and literally 30 seconds to hang the tv. Very sturdy mount and is fully adjustable to allow your tv to move up, down or even sideways.

Easy install of a quality built wall mount. The nice thing about this mount is the side to side adjustability. Our wall studs were off center, but the mount allows you to reposition the TV. Not to mention the frame was relatively light compared to the last bracket I installed.

I couldn’t be happier with this SANUS Elite wall mount. The quality was obvious as soon as I took it out of the box. It gives you a lot of confidence when you’re hanging a larger TV. I had Geek Squad install it with my new 77” LG C5 OLED, and the finished result is incredible. The TV sits perfectly on the wall with a clean, professional look, and the mount feels rock solid. The tilt feature makes it easy to reduce glare when needed and is a huge bonus without sacrificing how flush it looks when it’s against the wall. If you’re spending good money on a premium TV, don’t cut corners on the mount. This one is built to last and looks fantastic once installed. I’d recommend it to anyone looking for a high-quality, sturdy mount that makes your setup look like it belongs in a home theater. Five stars all the way!

This product is great. It articulates the tv perfectly so when more guest are watching they can get a better view of it. It is also easy to install and level out

Works really well holding up the lemon of a tv Best Buy sold me. I do not recommend buying anything Hisense without getting the extended warranty- your tv will get a gray/blue blotch on it within months of manufacturer warranty expiration. Image included. I like the tv mount though. Sturdy, easily adjusted, etc.

I initially wanted a full motion mount, but found out that would not be advisable with the steel studs that I have in my home. This mount was recommended so I gave it a chance, and I am very happy that I did. My new Sony OLED TV looks great on the wall. This mount is not full motion but can be tilted up or down and right to left. I especially like that it extends 6 inches off of the wall which will let me work behind my TV when I need too. Included in the box is an assortment of mechanical screws and mounting hardware sufficient for most TV’s and walls Geek Squad did the install for me and they did an amazing job. I have every confidence that my TV is safely and securely mounted on the wall

Really great product and packaging. This came with plentiful mounting hardware for different TVs, the cardboard tracing board was really helpful for getting the walls marked up, and it's holding a 65" TV with no issues. Because of our stud layout, there is no way to center a mount perfectly. The ability to slide the whole TV set left & right (wood stud mounting only, according to the manual) after mounting made for perfect placement. I was terrified at first to but a 60lb TV up on the wall but after securing the 4 bolts, I really felt it was gonna be safe up there.

I recently bought this Sinus Elite bracket for my “65 LG C4 and I am very happy with my decision to purchase this. The Bracket comes with a template included for installation. It took me about 45 minutes to install my tv on the wall. As for the functionality, the bracket does as advertised. It tilts 360! Up, down, left and right.I recommend this bracket if you are looking for a sleek and smooth operating bracket.

Look no further. If you have an extra large television like I do, this is the wall mount for you. The instructions are so easy to follow that anyone can do it. The Height Finder calculator located on Sanus’s website makes it a breeze to find out where to drill your holes. I will warn you though, make sure that you know where the mounting holes are on the back of your tv. If they are not centered, it will throw off the calculations and you’ll have to adjust for that. It can tilt forward, backwards, left, and right. Plus extend out about 7 inches. Overall this is the best mount that you can buy. Nothing negative to say at all.

This was easy to install. One thing I will say are the sliders on back of TV mounting bracket that allows the TV to tilt could be loose from factory. Simply tighten them to correct. The spacers provided for mounting the TV on the mount are a little cheap looking but do work. I like the fact I can pivot the TV far enough from the wall to allow better access to wiring and behind tv. This mounting bracket feels very well made and solid holding the TV.

This mount has worked perfectly with my 65" TV. It feels very sturdy and secure, giving me confidence that the TV is safely supported. I also like the tilt feature, which makes it easy to get a comfortable viewing angle and reduce glare when needed. Once installed, the mount has been unobtrusive and keeps the setup looking clean and professional. Overall, it's a high-quality product that does exactly what I was looking for, and I would definitely recommend it.

Easy to hang. Love how it t can be tilted, moved forward and moved left to right. Comes with all the bolts and even a “level”