“I have a 25 year old Philips/Magnavox 19" color tv in excellent condition. It has only a 75 ohm Ant/cable plug in the rear of the tv. Recently I purchased a Alura-tek Digital Converter Box and RCA Amp indoor HDTV ant. Please give step by step set-up.”
Answer This Question
1-1 of 1 Answer
BASIC SETUP 1. The indoor antenna connects to the RF IN on the back of the TV box. 2. Then the TV box connects to your TV either using HDMI cable or the red, white, and yellow cables. 3. Do not connect the RF out to the TV. 4. After powering on your TV and TV Box you need to set your TV to the INPUT you used (HDMI 1 or 2, VGA, etc.). 5. Power on the TV Box with your Aluratek remote. You then TAP the menu button on the remote control for the Aluratek TV Box and go to channel search and run that. You can use the arrow keys on the remote control to move across the tabs at the top of each menu. The channel search will find the local channels available in your area. This can change depending on where the antenna is placed in the home. USB Thumb Drive: Use a 32GB card or smaller in size for best results. USE INDOOR ANTENNA The antenna is the crucial part. In addition to the antenna a lot depends on where it is placed and the location in the home or building and what is possible to be picked up in your area. I often have to move my antenna slightly to adjust quality. ----->>>> If you need more info contact [email protected]
Sorry, there was a problem. Please try again later.