“While I found the unit easy to set up, the USB port does have its quirks. If I program to record in the future and TURN OFF the box it doesn’t record. When I went to look for my recording after turning on the box it says no USB connected even though it is”
Answer This Question
1-2 of 2 Answers
SETUP RECORDING ON TV CONVERTER BOX You will need to go to the remote control, tap menu, navigate over to the USB tab. choose PVR configure, choose format and make sure your USB stick or drive is formatted for recording. Then back out of that page and go to Record Device. You will see your Disk (C: USB1), choose Timeshift size and set that to 4.0 GB. Then exit. To record you can simply choose a channel to record and hit the red REC button. Recording will begin immediately. To set a show to be recorded go to the channel you want, Tap the EPG button on the remote, scroll down or up to choose the show you want to record, hit the OK button, then an EVENT ADD screen will appear. Scroll to the bottom of this screen and you will see a MODE : RECORD section. Tap on OK and that show will be scheduled to record. The screen will show you the event, program, date, time, and the repeat status which defaults to ONCE. You can edit the repeat status in the previous menu (EVENT ADD). If the show is scheduled to record you will see an Orange, Red, Yellow ball that appears next to the show in the PROGRAM GUIDE, which you can see by tapping the EPG button. This should get you going.
Sorry, there was a problem. Please try again later.I had the same problem. This unit does not work well with USB drives. I found it works more reliably with an actual hard drive hooked to the USB port.
Sorry, there was a problem. Please try again later.