“I just bought this item and it constantly keeps beeping. I unplug the unit and it stops for awhile then when I come home again it’s beeping again. Always has a flashing red light also. No instructions were included in the box, I’m About to return it.”
Answer This Question
1-3 of 3 Answers
A flashing red light and constant beeping on the APC BE600M1 usually means there’s a fault condition—most commonly a disconnected battery, overload, or battery failure. Here’s what you can try before returning it: - Check the battery connection: Open the battery compartment and make sure the battery is securely connected. A loose or unconnected battery is a common cause of this issue. - Reduce the load: Unplug all devices from the UPS and see if the beeping stops. Then plug in one low-power device (like a modem) and test again. - Let it charge: Leave the unit plugged in (with the power button off) for at least 10–24 hours to allow the battery to fully charge. - Reset the unit: Some users have had success by unplugging the UPS, removing the battery, pressing and holding the power button for 10 seconds, then reconnecting everything. If the red light and beeping persist after these steps, the unit may be defective or the battery may be unusually depleted. You can find more troubleshooting tips in APC's official guide.
Sorry, there was a problem. Please try again later.Did you open the side of the case and connect the battery? Yes the manual is a joke at best. You also have to press and hold the power button for 2-3 seconds to turn in online.
Sorry, there was a problem. Please try again later.You can silence the alarm, but the better option would be to get online and look find out what is wrong. It should display an error code that you can look up and resolve the issue. You can also get the owners manual online.
Sorry, there was a problem. Please try again later.