is there any assembly needed null

Assembly, not really, but you do have to remove some screws that are used during shipping. You also need to remove the AMS from the bed area and connect the PTFE tubes. You can also connect the external spool holder, but I don't think there's anything to screw in, though. Either way, the whole process from unboxing to use is easily less than 30 minutes.

Assembly is very simple. The AMS unit (that holds 4 spools of filament and automatically loads from the spool you choose) comes inside the main housing. Assembly took me 30 minutes because I spent time learning about each element. If I did it again it would probably only take 20 minutes. It comes with a tool kit and you only need to use 2 of the tools. There are a few screws to remove and re-install. You will also attach a few PTFE tubes to deliver the filament. The video on the Bambu Labs website is easy to follow.

“is there any assembly needed”

Asked by AnthonyC 5 months ago

Answer This Question

See all questions & answers

Bambu Lab - P2S AMS Combo 3D Printer - Gray-Angle_Standard

1-4 of 4 Answers

Very minimum
Answered by EricW 4 months ago
Sorry, there was a problem. Please try again later.
Assembly, not really, but you do have to remove some screws that are used during shipping. You also need to remove the AMS from the bed area and connect the PTFE tubes. You can also connect the external spool holder, but I don't think there's anything to screw in, though. Either way, the whole process from unboxing to use is easily less than 30 minutes.
Answered by tonztime 4 months ago
Sorry, there was a problem. Please try again later.
Assembly is very simple. The AMS unit (that holds 4 spools of filament and automatically loads from the spool you choose) comes inside the main housing. Assembly took me 30 minutes because I spent time learning about each element. If I did it again it would probably only take 20 minutes. It comes with a tool kit and you only need to use 2 of the tools. There are a few screws to remove and re-install. You will also attach a few PTFE tubes to deliver the filament. The video on the Bambu Labs website is easy to follow.
Answered by JamesG 5 months ago
Sorry, there was a problem. Please try again later.
Yes but not hard
Answered by StephenD 5 months ago
Sorry, there was a problem. Please try again later.