“How can you tell when the drying is complete? Is there an indicator light?”
Answer This Question
1-3 of 3 Answers
There is a signal dinging when the wash is complete. You have to open the door and turn the unit off to discontinue the alert. There are no light indicators visible since all controls are on top of the door and not visible when the door is shut. I find this an inconvenience and would prefer to have the controls on the outside and accessible.
Sorry, there was a problem. Please try again later.There is No external indicator light You open the door and there is a light that says clean
Sorry, there was a problem. Please try again later.You can set the washer to beep when it's done; similar to a microwave's beep but just at slower pace. To enter options mode: 1 With the door open, press the On/Off button to turn the unit on. 2 One of the wash cycle LEDs will be flashing. 3 Press and hold down the > button, then press and release the Start button. Now release the > button. 4 The “Clean” LED and one other LED will be flashing. You are now in options mode. 5 Press the > button to select the option you would like to adjust. Then set the Cycle Completion Signal: 1 With the “Clean”, “Sanitized” and “Refill Rinse Aid” LEDs flashing, press the < button to change the cycle completion tone volume. The wash cycle LEDs will illuminate when you press <. 0 LEDs flashing = Cycle Completion Signal is OFF 1 LED flashing = low tone volume 2 LEDs flashing = medium tone volume 3 LEDs flashing = highest tone volume 2 Press Start to save your setting
Sorry, there was a problem. Please try again later.