“There's a "legal dust cover" that fits over legal size paper. How does it sit in the paper tray? There is no diagram in the manuals.”
Answer This Question
1-2 of 2 Answers
I don't use it but just figured it out. First, of course, extend the paper tray completely out until it clicks by pushing the blue tab on the right and pulling back, to accommodate the legal size paper. Then with the flat side up and the long straight side towards you, just lay the dust cover in place. It can be done with the paper tray pulled out or pushed in. The two round pegs on the bottom side of the dust cover fit into two holes in the front cover of the paper tray where you grab with your hand to pull it out. Took me a while to figure it out as well. In fact, I didn't even know what it was for. Once you get it the first time, it is quite easy. I agree, no instructions or diagram for this is unacceptable. Seems you are expected to figure everything out on your own or go online and download a manual, or look for answers on a forum like this. I included two picture of the cover in place and one just to show where the two round pegs go. Hope this helps.
Sorry, there was a problem. Please try again later.open the paper tray, there are 3 blue tabs for adjusting paper size. Once you have done that put the paper tray back in place but before you close the tray, position the "dust cover" so the two circles on the underside face outward toward you, then locate the corresponding holes openings on the tray, now place the dust cover so it all aligns and you are ready to close the drawer with a dust cover in place. caution: make sure the tray has been opened to hold 14" paper or the dust cover wont fit properly and the tray will not close
Sorry, there was a problem. Please try again later.
