“I have a Phantom 3 Pro. How do these mount? Do the screws go into existing holes?”
Answer This Question
1-7 of 7 Answers
Please see the installation guide at http://dl.djicdn.com/downloads/phantom_3/en/phantom_3_prop_guards_installation_guide_en.pdf There are also videos of how to do the install on YouTube.
Sorry, there was a problem. Please try again later.Yes, you remove the 2 outside screws from the motors and save them for later. The hex key provded is pretty long, so be careful not to over-tighten.
Sorry, there was a problem. Please try again later.Yes, you remove the two outermost motor screws and replace them with the two screws that come with each propeller guard
Sorry, there was a problem. Please try again later.yes with different screws
Sorry, there was a problem. Please try again later.Yes they give you longer screws to replace the old ones!
Sorry, there was a problem. Please try again later.I believe u take out the screws and replace them with longer ones that come with the guards.
Sorry, there was a problem. Please try again later.The propeller guards are mounted to the two outer holes for each motor. Remove the shorter original screws and use the longer ones supplied with the guards. Save the original screws for later use.
Sorry, there was a problem. Please try again later.