“Our existing front load washer has a real mildew / mold problem on the front gasket. No matter what I do, it is a constant battle. It’s an older machine though. What does this Electrolux do to avoid this issue?”
Answer This Question
1-1 of 1 Answer
Hello Goose, Thank you for reaching out to us! Please know that Front-load washers, including the Electrolux 2.4 Cu. Ft. Stackable Front Load Washer, are energy-efficient and water-saving, but they can indeed be susceptible to mold and mildew buildup. Here are some steps you can take to prevent and address this issue: Promptly Remove Laundry: Always remove your laundry promptly after the wash cycle completes. Leaving wet clothes in the washer can contribute to mold growth. Use HE (High-Efficiency) Detergent: Opt for high-efficiency laundry detergent and use the recommended amount. Excessive detergent residue can lead to mold buildup. Avoid Liquid Fabric Softeners: Liquid fabric softeners can leave a sticky residue that promotes mold growth. Consider using dryer sheets instead. Regularly Clean the Glass and Gasket: The door gasket (seal) and glass area are common spots for mold and mildew. Regularly wipe them down with a disinfectant to prevent buildup. Clean the Detergent Dispenser and Attachments Bi-Weekly: Mold and mildew tend to accumulate in the detergent dispenser. Remove the dispenser and clean it thoroughly. Also, pay attention to the slot where the dispenser sits, as it can harbor hidden mold. Keep the Washer Door Open: When the washer is not in use, leave the door ajar. Allowing air circulation helps prevent moisture buildup and discourages mold growth. Run a Dehumidifier in the Laundry Room: If possible, use a dehumidifier in the laundry area to maintain optimal humidity levels and reduce the chances of mold development. Remember that prevention is key. By following these practices, you can keep your Electrolux front-load washer clean and mold-free. If you notice any signs of mold, address them promptly to maintain a hygienic washing environment! - Owen
Sorry, there was a problem. Please try again later.