“IIf the filter pump gets clogged can I access and unclog”
Answer This Question
1-1 of 1 Answer
Hi there, thank you for reaching out regarding your question about the product. Yes, you can access and unclog the filter. Here are the following steps for your reference: Unplug the dryer and let it cool. Open the pump-cover (usually located near the bottom front or back). Place a bowl underneath to catch residual water. Squeeze the levers and pull out the drain duct. Let the water drain fully, emptying the bowl as needed. Remove the filter by turning it counter‑clockwise. Clean out lint and debris and verify the impeller spins freely. Rinse the filter under water, screw it back in, secure the duct, and close the cover tightly. - Jessica
Sorry, there was a problem. Please try again later.