1-5 of 5 Answers
The instruction is quite clear but sometimes the software might try to take over. Select Setup/Maintenance/Ink Cartridge Relacement - OK, START The printer will whir a bit as it purges the extra ink and repositions the heads for changing. Lift the top cover. See picture below. Put your finger on the compressible tab on the back of the ink and squeeze in while lifting the cartridge up. The Ink pops out might need a bit of wiggling. Shake the new ink cartridge, take the piece of yellow tape off the new cartridge. You will see a clear film over the place the ink comes out - leave that there it gets busted on install. Push it down - voila it is done. Push start again on the printer and it will take a few minutes to purge and get ready to print.
Sorry, there was a problem. Please try again later.Just pull it straight up to replace. Be sure it is pushed down completely when you replace.
Sorry, there was a problem. Please try again later.Push tab on back towards the rest of the cartridge. Pull up.
Sorry, there was a problem. Please try again later.There is JUST a tab to push, it THEN pops out very easily
Sorry, there was a problem. Please try again later.You can replace just the color that is needed. You just take out old cartridge and replace with new one.
Sorry, there was a problem. Please try again later.
