“A red light on the "filter" on the display came on. Now I can't get it to turn off.”
Answer This Question
1-10 of 16 Answers
I tried everything I could find online to help me with this problem. Then I tried one more time by pushing only the word “reset”. I did not push the red light. It worked!
Sorry, there was a problem. Please try again later.Red light on “filters and I cannot turn off Need a picture of your directions...
Sorry, there was a problem. Please try again later.Hi - The Upfront Filter design found on select GE Series and Profile Series over-the-range microwaves allows for easy access to the charcoal filter and requires no tools to change the filter. Open the microwave door and press the access panel above the cavity opening where it says "PUSH" to lower the panel door. Models with an Upfront Filter have a Reset Filter notification light on the control panel to indicate when it is time to change the filter. The light will illuminate after approximately 6 months of use to alert user to replace the charcoal filter (if used) and clean/replace the grease filters. Reset by pushing and hold 3 seconds. When the Filter Replace LED turned on, replace filter and press Reset Filter and hold for 3seconds to reset. If the filter light remains on after reset, try resetting the microwave electronics by unplugging or by turning off power at the circuit breaker for 30 seconds or so. If you need further assistance, we encourage you to contact GE Appliance Service at 1-800-432-2737 or conveniently schedule an appointment online: http://www.geappliances.com/service_and_support/service/ - Keep in touch! SUE@GEA
Sorry, there was a problem. Please try again later.GE's 3 seconds is more like 5 or more seconds. First thing to try is to hold the button down longer. If that doesn't work then unplug for a minute and plug back in. If that doesn't work you will need a repair.
Sorry, there was a problem. Please try again later.I unplugged my ge microwave then plugged it back in. I then followed the instructions right below the light it reset the light in three seconds like it says
Sorry, there was a problem. Please try again later.17 seconds and it beeps twice
Sorry, there was a problem. Please try again later.Replace the filter if dirty. Be sure to insert properly. Turn vent on. Push the word VENT and HOLD for 3 seconds. The light should go out. Turn vent off.
Sorry, there was a problem. Please try again later.You have to hold reset button for about 10 seconds on mine. Drove me crazy before I figured it out
Sorry, there was a problem. Please try again later.I had the same problem. I had to hit the cancel button first then then reset, and it worked for me.
Sorry, there was a problem. Please try again later.it shut off by depressing the word "reset" only, using a pencil eraser. Lack of instruction leads one to believe either the light is a button needing to be depressed ...or... the entire identification shown, " reset filter, hold three seconds" depressed successfully the one word "Reset"
Sorry, there was a problem. Please try again later.