“How do you rinse the stairs when using the stair attachment? Instructions only give info on shampoo and dry strokes, not rinsing after. You surely don’t leave all that shampoo sitting in the carpet.”
Answer This Question
1-3 of 3 Answers
There is a setting on the tank to just spray water as a rinse. After spraying shampoo and vacuuming the sudsy water, spray the rinse water and vacuum it up.
Sorry, there was a problem. Please try again later.There is a knob on the water/cleaning solution tank to alternate between washing and rinsing. You have to manually turn it,so if you have a lot of stairs you will have to keep going up and down or step on wet carpet.
Sorry, there was a problem. Please try again later.When cleaning the stairs, position tool against the riser and slightly press it into carpet pile. Press the trigger and pull the tool slowly over the carpet (second wet stroke). Release trigger at end of stroke. Lift tool, and position it against riser. Pull tool slowly over carpet without pressing trigger (dry stroke). Overlap strokes by 1/2 inch to help prevent streaking. It is best to alternate wet and dry strokes as described above. End with more dry strokes to aid in faster drying of carpet. To avoid saturating carpet, do not use more than 4 wet strokes over any one area. Always end with dry strokes. To rinse with water only, set Wash/Rinse Selector to rinse and follow previous steps.
Sorry, there was a problem. Please try again later.