1-4 of 4 Answers
The 36v battery can be replaced if needed. When checked mine hald about 41.5v fully charged. It is held in with 4 nuts. You remove the bottom plastic plate. There are 17 - 2mm allen head screws. There is a sticky gasket between the plastic plate and bottom housing to seal out moisture. Once removed the battery is fastened in by 4 nuts and a power disconnect. Didn't weigh but, its maybe a couple pounds. Shape is rectanglar and I would guess about 10-12 long, about 3" wide and 2" depth. I took mine apart because it would not power on but, the battery check out fine. There is also a small controller box in the battery compartment that I suspected might be my problem or the "on/off" display board in the steering head. By the way the cover can be easily snapped off the steering head with a flat knife to access the display board. I did not have a way to check the controller box or display board so don't know if its my problem or even where to get parts? Maybe this helps some.
Sorry, there was a problem. Please try again later.Contact Hover Journey-1 They will answer questions and they have lots of parts
Sorry, there was a problem. Please try again later.Not removable. Set in and covered with a plate held by several Phillips head screws. Manual has wording that leads one to believe that unscrewing any of them or opening the battery compartment voids warranty.
Sorry, there was a problem. Please try again later.Battery CANNOT be removed . Unless your talking about replacing the battery completely . You can removed the battery if it is damaged or no longer working . Other then that will cause scooter yo overrode and no longer work
Sorry, there was a problem. Please try again later.
