A:AnswerPlease check the User Guide available under the Overview section.
Also here is the link:
https://files.bbystatic.com/L1LOPMR7CcSTDNYZQzvHLQ%3D%3D/NS-TWM16WH9_19-0512_WEB_V5_EN_Final%2Blr.pdf
A:AnswerLooking from the front, it's on the left side. You can swing it to the right (still attached to the left side) but unfortunately, the hose is not very long, and it's made of cheap plastic that if you squeeze the drain hose even slightly too much, it will bend/make a dent on the hose... hope this helps...
A:AnswerThe drain hose is attached to the washer at the factory. The recommended height for the drain standpipe is 35 in. (90 cm). The drain hose must be routed through the drain hose clip to the standpipe. The standpipe must be large enough to accept the outside diameter of the drain hose.
A:AnswerMine is hooked to the faucet and not perm installed. On washer, leave setting on cold, always. Then turn on both hot and cold to fill washer. You can get very warm water. I tried with only hot water, and it did not fill. Thats just my experience.
A:AnswerWithout insulting your intelligence, why don't you go to Best Buy's product page and view them there?
NS-TWM16WH9 1.6 CU FT TL Portable WASHER
Cheers!
A:AnswerTo fill your washer in the correct amount of time, the water pressure needs
to be between 14 and 70 psi (100 to 600 kPa).
David M. - Insignia Support
A:AnswerDirections say to level the machine before using, so you'd had to level it all the time, and support the steele tub during transportation. That's my guess!?
As long as you have electricity, water, drainage, and level ground it should work
A:AnswerOnly connect it to cold and have the hot water inlet capped. Then turn on your water to the desired temperature. If you want it hot, then have your faucet only run hot water.
