“What are specs for the water supply elbow that is customer provided? Provide a part number or link? Installing at remote site and need to bring it with me. Old dishwasher has standard supply input (3/8" I think), but the manual says elbow required.”
Answer This Question
1-2 of 2 Answers
Your answer is incorrect! I had to unbox it to make sure before I take it to the remote install location. It is NOT 3/4" NPT. It is a standard 3/4" FHT (garden hose type connector) to 3/8" compression. It is a standard dishwasher connection, and the elbow is available at any hardware store and is sold as a dishwasher connection elbow. Too bad its not included with the dishwasher, not specified in the installation manual, and Insignia customer service agents don't even know the right answer!
Sorry, there was a problem. Please try again later.For the Insignia™ 24” Front Control Built-In Dishwasher, you will need a 90° water supply elbow with a 3/8" compression fitting on one end and a 3/4" NPT (National Pipe Thread) fitting on the other end. This elbow is necessary to connect the dishwasher to your water supply line. If you need any further assistance or have more questions, feel free to ask!
Sorry, there was a problem. Please try again later.
