1-4 of 4 Answers
Right steps for starting the dishwasher: Select the cycle and option; Press the “Start/Cancel”; Close the door within four seconds of pressing “Start/Cancel”. And the dishwasher will begin running. If you are not ready to run it yet, just please close the door without pressing ‘’Start/Cancel”, the dishwasher will not run. If you want load more dishes while it’s already running, and you close the door without pressing “Start/Cancel”, the dishwasher will beep for reminding user. Therefore if you are not ready to run it yet, please first restart the “Power” to clean up the running, and then close the door without pressing ‘’Start/Cancel”, the dishwasher will not run. Please make sure the control panel is without dirty and is not near with something in order to touch the “Start/Cancel” by mistake. If above conditions are all OK ,Please schedule a Service Visit. It is most likely the door switch or the Control Board is not working normally.
Sorry, there was a problem. Please try again later.there is a cancel button and a power button - i imagine you can press them to cancel the cycle...there is also a delay start option...manual
Sorry, there was a problem. Please try again later.I think the unit has to be powered off.
Sorry, there was a problem. Please try again later.1. Right steps for starting the dishwasher: Select the cycle and option; Press the “Start/Cancel”; Close the door within four seconds of pressing “Start/Cancel”. And the dishwasher will begin running. 2. If you are not ready to run it yet, just please close the door without pressing ‘’Start/Cancel”, the dishwasher will not run. 3. If you want load more dishes while it’s already running, and you close the door without pressing “Start/Cancel”, the dishwasher will beep for reminding user. Therefore if you are not ready to run it yet, please first restart the “Power” to clean up the running, and then close the door without pressing ‘’Start/Cancel”, the dishwasher will not run. 4. Please make sure the control panel and counter is without dirty and metal part and is not near with something in order to touch the “Start/Cancel” by mistake. 5. If above conditions are all OK, please schedule a Service Visit. It is most likely the door switch or the Control Board is not working normally.
Sorry, there was a problem. Please try again later.