“If the bin and shelves are removed, will a cylinder that is 8.5" in diameter and 25" tall fit? I am OK with cutting the molded shelves off the inside of the door if needed. Wondering for a homebrew beer keg. Thank you.”
Answer This Question
1-2 of 2 Answers
To anyone interested, I went ahead and purchased this fridge a few weeks ago. My interests in using this product were low price and lack of space (recently retired to Florida with a one floor home and not a lot of free space). I cut the molded plastic forming the shelves/drink racks all the way around the edge of the door (pulled out the seal first), which was quite easy. Pulling that piece off was a little difficult as it was adhered to the foam insulation on the door and a fair amount of insulation came off with it. I used Great Stuff Window and Door (low foaming) spray foam to fill in the gaps. I then had to carve out a little of the door foam and the keg fits! The CO2 tank and regulator sit on the shelf above the compressor. Works great! I may carve out some more foam to fit a second keg in. Very satisfied as it is much less expensive than a purpose-built kegerator and takes up little space.
Sorry, there was a problem. Please try again later.No, the inside area above the compressor is only 22" tall, but it is 10" deep by 15.5" wide, so the height is the issue.
Sorry, there was a problem. Please try again later.