“How do I use this as there were no instructions in the box”

This question is for: Insignia™ - Key Ring Case for Apple AirTag - Black

Asked by autumn 3 years ago

Answer This Question

See all questions & answers

Insignia™ - Key Ring Case for Apple AirTag (3-Pack) - Purple, Pink and Blue-Front_Standard

1-10 of 20 Answers

You just push the Air Tag into the rubber holder and stretches to fit it, like putting a rubber bumper around a phone. Then you just clip the holder on to what you want the track.
Answered by Brian 3 years ago
Sorry, there was a problem. Please try again later.
Just put the AirTag into the silicone.
Answered by InsigniaCustomerSupport 3 years ago
Sorry, there was a problem. Please try again later.
You just take the AirTag and push it through the opening of the keychain case. It’s super easy to do.
Answered by Sonya 3 years ago
Sorry, there was a problem. Please try again later.
You tag your AirTag and push it into the center of the silicone ring until its secure.
Answered by Loady 3 years ago
Sorry, there was a problem. Please try again later.
Just push the AirTag into the opening and the rubber will hold the Tag. the carabiner loop is straight forward as it get.
Answered by kerkdjerk 2 years ago
Sorry, there was a problem. Please try again later.
You simply snap your air tag into it.
Answered by toolie821 3 years ago
Sorry, there was a problem. Please try again later.
Just slip in the AirTag
Answered by Mark 3 years ago
Sorry, there was a problem. Please try again later.
Separate the two halves, insert the AirTag, close the two halves.
Answered by timned88 3 years ago
Sorry, there was a problem. Please try again later.
Simply insert the AirTag in the center of the holder
Answered by Cathy 3 years ago
Sorry, there was a problem. Please try again later.
Just slip it over the air tag. It fight very snug but is a great asset
Answered by AndreaV 3 years ago
Sorry, there was a problem. Please try again later.

1-10 of 20 Answers