1-8 of 8 Answers
The part on the back of the phone holder that comes out a bit (the part with the circle of dots logo in it) has a little cutaway you put your finger in to open it. Then you can expand it! It takes a lot of force to open it the first time. Then it snaps back to lock in place. Hope this helps?
Sorry, there was a problem. Please try again later.Make sure you remove your phone case for a secure fit
Sorry, there was a problem. Please try again later.The grip is spring loaded and it is very strong. A larger phone may not fit. The package says the phones can be 2.36 inches to 4.09 inches.
Sorry, there was a problem. Please try again later.Did you release the shoe arm?
Sorry, there was a problem. Please try again later.This extends hold both sides and pull...
Sorry, there was a problem. Please try again later.If you pull the tab out on the back of the grip, it loosens the grips to place your device. Otherwise, if that tab is pushed in, the grips are locked. If the grip doesn’t loosed with the tab pulled outwards, you may have a faulty product.
Sorry, there was a problem. Please try again later.Release the center tab by pushing it away from the grip. Do not pull it too hard as you can potential break the tab.
Sorry, there was a problem. Please try again later.Flip out the tab on the back prior to insertion or removal. It is easier if you have it mounted on the tripod first.
Sorry, there was a problem. Please try again later.
