“I have a factory head unit with speaker line connections to a 4 channel amp that then runs to the 4 door speakers. At what point in this chain do I tap into the speaker wires with this sub?”
Answer This Question
1-1 of 1 Answer
I tapped directly into my rear speaker wires without any issues. You also have the option to power the unit with RCA cables. It's capable of receiving either Hi (speaker-level) or Low-level (RCA) signals from your source unit and then you just set the Input Level switch on the side panel to match the outputs of your source unit. If you use RCA cables from the kicker into the back of your stereo, you don't tap into your speakers. If you go that route, you do have to connect the remote turn-on lead using 18 gauge wire from the remote turn-on lead on your source unit to the terminal labeled REM on the power harness. If you tap into your speakers, you don't need the remote turn-on wire and you set the kicker to DC Offset.
Sorry, there was a problem. Please try again later.