A:AnswerThe following pieces are included in the kit;
Qty 4 30" long sections of straight channel
Qty 3 Couplings
Qty 2 flat 90 degree elbows
Qty 1 inside 90 degree elbow
Qty 1 outside 90 degree elbow
Qty 1 tee
A:AnswerThe adhesive provided on the Cordmate II, as well as our other raceways, bonds to the wall quite strongly. This is very desirable in most applications. However,if you try to remove the Cordmate II from the wall after it sticks it is likely to cause some damage. It will either leave behind a residue which will be difficult to clean or pull some of the surface of the drywall with it as it comes off.
If that happens, here as some suggestions as to what you can do to remove the tape residue:
The double-sided adhesive used on the back of the raceway has a foam core that can be cut with a razor blade if you are very careful. Use a "filet" technique, pulling up as you go. Then you'll be left with about 1/2 the thickness of the tape still on the wall. You might try rubbing what is left on the wall off manually, wearing rubber gloves. Or you can try scraping it off with a putty knife.
If the wall has a gloss finish then you can also consider using an alcohol based solvent to remove the tape residue.
If the wall has a flat finish the problem is a bit more difficult because the finish may absorb the solvent that is used.
In all cases, I would suggest that you first try in an area that is not visible.
A:AnswerYes it can cover an HDMI cable. If there are several cables, you should use the;large' capacity kit. I purchased both kits (just in case) but I ended up using the small kit and returned the large kit. At the store, the credit card was credited in an instant; excellent customer support.
A:AnswerThe Cordmate II is not suitable for use on the floor. However, we offer the Corduct Overfloor Cord Protector for that purpose. Below is the URL for the web page where you can see more details about the Corduct on the Legrand web site.
https://www.legrand.us/wiremold/at-home/cord-organizers-and-covers/corduct-overfloor-cord-protectors/cocp-corduct-cord-organizer.aspx
A:AnswerHonestly i would just paint over them. They are white and if your painting your walls white then paint over. Theres no moving them once you put them on.
A:AnswerHi Paula, while they are not wide enough to run a plug through, the covers open up and easily click back into place! These are perfect for a TV or other wall mounted object!
A:AnswerThe adhesive strip on the Cordmate II raceway should be mounted to clean, dry, grease-free, smooth surfaces. Concrete walls usually are rough and somewhat textured so I don't believe the adhesive strip will hold very well. In such applications, you can install the raceway to the wall using #8 (5/16" head size) pan head fasteners.
A:AnswerIt doesn't come with any. Perhaps you could talk to a clerk in a home/hardware store and explain what you're thinking about. They might come up with an idea. Tht concealer tubes/covers are approx 1/4" x 1" and can hold up to 4 cables/wires. ** If you wash the wall real well using rubbing alcohol or something non-greasy, let it dry well. The adhesive will stay stuck.
A:AnswerI am not the company. I am a customer but have the package right here. Step #1 Cut Channel to desired length. Step #2 Insert cords through side slot and snap shut. Step #3 Peel liner off and press firmly against *** CLEAN, DRY WALL ** Do not use textured walls. Wall where applying should be cleaned with rubbing alcohol or a non-greasy cleaner, dry real well prior to applying.
