“The chimes on my washer just suddenly stopped working. No info in the manual on this. How do I turn back on. Thank you.”
Answer This Question
1-10 of 21 Answers
Turn on power, turn dial to NORMAL, press SIGNAL button in bottom-right of panel. Light above SIGNAL will come on and you'll hear a "ding".
Sorry, there was a problem. Please try again later.Mine went off (I think my son managed to turn it off without meaning to), but if I turned on the washer, then held down the "COLD WASH" button (upper left corner) it turned the signal back on. Hope you figured it out!
Sorry, there was a problem. Please try again later.The washing machine plays a melody when the wash cycle has finished. The volume of the melody is adjusted using the signal button. Press the signal button repeatedly to adjust the volume of the signal. When no signal is heard, the signal is off. The volume settings are low-high-off. The signal volume can be adjusted at any time as long as the washer is turned on. ^CP
Sorry, there was a problem. Please try again later.Chime quit. Press start button, then start, the right top cold wash signal button for 3 seconds and then chimes, turn on.
Sorry, there was a problem. Please try again later.I reset mine by pressing "power" and "cycle signal" buttons at the same time and hold it for 15 to 20 seconds.
Sorry, there was a problem. Please try again later.11-6-2023 Chimes went off. Nothing seemed to turn them on. The on this site I found do this, Start, dial to Heavy Duty, the press Cold button for 3 seconds, Chimes come on. Then all chimes work again. Thank you.
Sorry, there was a problem. Please try again later.Signal button on lower right keypad.
Sorry, there was a problem. Please try again later.I have an LG WT7400CV. The chime melody all of a sudden stopped sounding. No mention of how to restore it in the manual. I ended up pressing the button labeled "Signal * Control Lock" in the lower right corner of the control panel. That did it! That is the on/off button for the chime.
Sorry, there was a problem. Please try again later.On the newer models, hold the DRY LEVEL button (lower left corner) for 3 seconds
Sorry, there was a problem. Please try again later.Tried all the options and nothing worked…. on my machine I have a cold wash, signal button all the way over top right side of my machine. Held that until it beeped. Praise God it worked!
Sorry, there was a problem. Please try again later.
