“Aluminum dryer hose Is the aluminum dryer hose provided with the dryer? if not what is the length i need to buy? What is the diameter? Is it a standard 4" hose?”
Answer This Question
1-3 of 3 Answers
Ours came with all the hoses, etc. for installation, including the water hoses and the splitter. Was no issue at all for installation.
Sorry, there was a problem. Please try again later.The hose was purchased separately. It comes in a pre-packaged kit that gives you the correct length and diameter for the set-up built into laundry rooms.
Sorry, there was a problem. Please try again later.The length depends on your space and the required elbows/distance. Please take a look at the quote below from the manual and the attached image. "Follow the guidelines below to maximize drying performance and reduce lint buildup and condensation in the ductwork. Ductwork and fittings are NOT included and must be purchased separately. • Use 4-inch (10.2 cm) diameter rigid or semirigid metal ductwork. • The exhaust duct run should be as short as possible. • Use as few elbow joints as possible. • The male end of each section of exhaust duct must point away from the dryer. • Use duct tape on all duct joints. • Insulate ductwork that runs through unheated areas in order to reduce condensation and lint buildup on duct surfaces. • Incorrect or inadequate exhaust systems are not covered by the dryer warranty. Failures or poor performance caused by such exhaust systems will not be covered by the dryer warranty."
Sorry, there was a problem. Please try again later.
