“How can you conform these to edges? Are these the kind you can cut to make corners (I've seen many light strips this way)”

1-2 of 2 Answers

• I did not make a sharp 90 degree angle in corners - instead adhering the strip up to about 1/2” from the corner, then gently bending it and adhering the remainder of the strip about 1/2” away from the corner, continuing on. The adhesive holds just fine even with this gap and I think its better for the longevity of the strip not to have its wires bent as much as hard angles would require.

  Answered by dustininsf 4 years ago

  • Verified Purchase
  • 

  Helpful (1)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• These lightstrips are flexible and and bend around corners. They can be cut, and will still function up to the point of the cut

  Answered by Nanoleaf Product Expert 4 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.