“Is there supposed to be a sizeable gap between the brush head and the handle when connected? I don’t think it effects performance but water/toothpaste tends to get in the gap and hard to clean . Any solutions ?”
Answer This Question
1-3 of 3 Answers
I have no gap on mine. And I usually remove the head and clean it after use.
Sorry, there was a problem. Please try again later.No. When pushed on appropriately there should not be a gap. Mine has a nice tight fit.
Sorry, there was a problem. Please try again later.Been using mine for a month, no issues with cleaning or performance; just pull off the head and rinse it under running water (can run water down the stem or over the head, makes no difference). The handle can be rinsed the same way (the manual shows running water at the joint of the handle at a 45-degree angle so you don't want to immerse it). Running water over the charger is a no-no, manual states wiping with a damp cloth...as well wiping parts (I do this) and letting them air dry before reassembly (I don't do this). I use a charcoal toothpaste so it's pretty obvious where I need to clean my brush!
Sorry, there was a problem. Please try again later.