“How to open otter box defender m4de moto z forçe droid edition”
Answer This Question
1-1 of 1 Answer
I have an iPhone instead of an android, but the concept will be practically the same for both. First, you need to remove the rubber shell from the case. Make sure you open any flaps covering ports, such as the charging port or headphone jack. After that begin to work the shell off of the plastic case, working your way around the entire phone. The shell fits snugly around the plastic case, but it will come off. Do not be afraid to bend and stretch the rubber shell a little, just use caution with any of the port covers, to not use too much force and risk ripping them off. Once you have gotten the rubber shell off of the plastic case, turn the phone over, and look at the back of the case. You will notice several points where the front and back of the case snap together. Pick one, and using your fingers, slightly pull outward on it to release it. I recommend choosing two clips that are side-by-side to start, such as one on the top or bottom, and the next one over on the side. Once you have a couple of them released the rest should be easy. Make sure your phone screen is free of any dirt, dust, or lint, and place your phone facedown into the portion of the case with the screen protector. Leaving your phone facedown, take the back of the case and put it on the back of your phone. Now pick up the entire unit as a whole, and begin squeezing around the edges of the case until you begin to hear the clips lock into place. Once you have all of the clips locked down, replace the rubber shell onto the plastic case. Congratulations! Your new OtterBox is ready to protect your phone.
Sorry, there was a problem. Please try again later.