“How and where do i open to plug in to charge the light?? Afraid to pull to hard on the wrong place”
Answer This Question
1-8 of 8 Answers
Pull (stretch) the beanie outward away while holding the plastic LED in place. Start with a corner.
Sorry, there was a problem. Please try again later.Peel/pull back the extreme outer edge of the rubber edging and the whole thing comes out.
Sorry, there was a problem. Please try again later.You gotta basically rip it out from the rubber corner, it takes a lot of force very crappy design. It also flashes continuously while you’re charging for 6.5 hours. so you might want to wait for something else or maybe wait for the next version which I’m sure they’ll improve. I would not be surprised if many complain about it.
Sorry, there was a problem. Please try again later.It’s very secure. You have to follow the inner inseam. Not threaded threaded area.
Sorry, there was a problem. Please try again later.Its rubber just pull hard took me awhile to figure it out
Sorry, there was a problem. Please try again later.Loosen it all the way around using something flat I used a wrench from a halloween decoration, worked perfect easiest to work on the back corner to get it to release!
Sorry, there was a problem. Please try again later.Have to open with something sharp right on the edge
Sorry, there was a problem. Please try again later.The light has a rubber ring around it. You just peel that back and it comes right out. The packaging includes directions on how to remove it to help make it easy.
Sorry, there was a problem. Please try again later.
