“How do I change the heads? There was no owners manual with it and I am unable to remove the standard head, would like to use the nose/ear trimmer.”
Answer This Question
1-10 of 11 Answers
Hey not sure if you figured it out. You actually place your thumb firmly near/below the blades of the razor teeth and press up and away from the unit. It takes some force depending on which head you are removing. The standard head takes a bit more force than say the nose trimmer head.
Sorry, there was a problem. Please try again later.Pull up on metal head (teeth end), and it will pop off from body of trimmer. Replace with the smaller attachments and reverse process when finished using.
Sorry, there was a problem. Please try again later.Just try to pull off the head. It should come out
Sorry, there was a problem. Please try again later.not really an answer just was wondering if anyone got a manual with the mg3000,because i did'nt ethier
Sorry, there was a problem. Please try again later.I know im very late but just pull the head upward and foreward tightly. I thought i was going to break it but it's fine. I dont use the nose trimmer though its abit rough.
Sorry, there was a problem. Please try again later.Either I'm becoming very weak or you have to have the strength of a gorilla to detach the head that comes already installed from the body of the unit. I haven't been able to do it.
Sorry, there was a problem. Please try again later.Billfred The trim head pops off. put your thumb on the trim side and push away from unit.
Sorry, there was a problem. Please try again later.You just pull up and out the head attachment part and reverse it to put it on.
Sorry, there was a problem. Please try again later.Simply push up on the head to remove.
Sorry, there was a problem. Please try again later.Mine had a paper manual. Maybe put name & model in computer search to get. It just pulls off - go on the blade side & push towards the back of it.
Sorry, there was a problem. Please try again later.