“How do you recommend to clean the lines? Our flow of water slowed down so it takes longer to fill a glass or picture of water.”
Answer This Question
1-1 of 1 Answer
1. Turn energy saving switch to OFF. 2. Unplug power cord from wall outlet. 3. Remove water bottle and place probe on hanger. 4. Move appliance away from wall to gain access to the back. 5. Remove remaining water from reservoirs by dispensing from the hot and cold taps into a pitcher. 6. Remove the cap from a spare empty 5 gallon bottle. Pour the bleach and tap water into the empty bottle. 7. Attach the cleaning bottle to the dispenser. 8. Slide the bottle in and close the door. 9. Plug power cord into a grounded wall outlet. 10. Turn energy saving switch ON. 11. Allow the bleach solution to fill the reservoirs. 12. Wait 10 minutes then drain the water from the reservoirs as described in step 5. USE CAUTION. Water will be HOT. 13. Turn energy saving switch OFF. 14. Repeat the flushing process in steps 6-13. This time with Hot tap water only. 15. Place a two bucket in the back of the appliance and remove the drain plug and cap. A Philips screwdriver may be required to remove the cap. 16. Replace the silicon plug and drain cap. 17. Return the unit to its location, install a fresh water bottle, plug the power cord into the grounded wall outlet and turn the energy saving switch ON.
Sorry, there was a problem. Please try again later.