1-5 of 5 Answers
You likely already know the answer after all this time, so I'm putting a reply here in case someone else comes across the question while shopping. It doesn't come with a gas dryer install kit by default, that's an extra, so if someone included it for you, they won't necessarily include it for anyone else. For the steam part, you simply need a short piece of hosing. This ships with a Y fitting to split the cold water faucet into two and a short (12" or less) hose piece in case you need to use that from the cold water feed and then put the Y splitter at the end, but that still won't be enough to reach the inlet on the dryer, which is on the very bottom right (when looking from the back). So you'll need a piece of hose that's male on one side, female on the other, and will get you the rest of the way to the floor level to reach the inlet on the dryer. No specific part needed, although as with anything, it's always good to use the steel lines to help prevent a rupture in the line. the piece of hose they give with it is a standard rubber hose section, not braided metal sheathing or anything.
Sorry, there was a problem. Please try again later.Hi sledge, Gas lines (for gas models) that must meet national and local regulations and an exhaust system made of rigid metal or flexible stiff-walled metal exhaust ducting. ^Rosi
Sorry, there was a problem. Please try again later.You need a steam dryer installation kit. Make sure you have that when they i9nstall it.
Sorry, there was a problem. Please try again later.You will need the kit for the gas as well as a longer hose unless your connection to water is within a foot. I had to buy a 6 foot water hose to connect. Easy connection. You can get any of that at any hardware store ....I mean Best Buy
Sorry, there was a problem. Please try again later.All you need is a short water hose for the steam feature. I found a 6Ft. hose in the plumbing dept. at Home Depot.
Sorry, there was a problem. Please try again later.
