“My space is almost exactly 66 5/8 tall. It would probably rub putting it in. How much room is needed above / sides for ventilation? Can the wheels be removed? If so, how much shorter would the unit be?”
Answer This Question
1-3 of 3 Answers
I have been here, own rental units, and personal home. Wheels must stay on, at times, adjustment for rock, may be done, but is a lot of work, to pick up 1/4 inch. (most fridges have locked rear wheels, only the front will go up/down, for rock, or to gain clearance). Most measure over hinges, but hinges, 99% of time, stay out of cabinet. Just measure the fridge itself, tight is no problem. Just need 1/2 inch on sides, air is drawn to rear, and vented out bottom of fridge, you can feel the air on floor when fridge is running. Fan is blowing condensate from cycle out to vent, do not block. Last way to fit new fridge, that is tight, also have done. The trim board on cabinet, is usually an inch below cabinet bottom, Trim the trim board within a 1/2 inch of cabinet door,(or what ever is needed), and you get a perfect fit. Do not forget to stain new raw wood, if no stain, magic marker, just darken new wood, nobody will ever notice. Just apply common sense to a problem, most problems can be solved if you have the ability. This works, only if the size is close and tight. Hope this helps.( This advice is geared towards a unit that is built in).
Sorry, there was a problem. Please try again later.Our space only has 1/4 inch on each side between the unit and cabinet, but we have 2 inches open above, so there is a way for air to circulate, which is important. The wheels will make it much easier when you pull it out on occasion to vacuum behind it. It's also important to keep the compressor dust free.
Sorry, there was a problem. Please try again later.Hello Arizona. The wheels on this Whirlpool® Refrigerator cannot be removed. Please visit https://bit.ly/3DpOTI8 and refer to page 7 for more information regarding the spacing needed around the Refrigerator.
Sorry, there was a problem. Please try again later.
