“Where des the fabric softener go since there is no dispenser?”

1-3 of 3 Answers

• You have to wait around until it gets to the rinse cycle to add it. The worst news is there's only about 2" of water in each load so good luck getting the fabric softener to spread out. I tried adding some water with my softener to the 2" I found in there & then my washer emptied itself of all water & was attempting to rinse my clothes with NO WATER!

  Answered by Whytdrgn2006 3 years ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Directly into the tub at the correct point in the wash cycle.

  Answered by KEK2 3 years ago

  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Please visit https://bit.ly/3cKYHlB and refer to page 3 for more information on using fabric softener with this Whirlpool® Washer.

  Answered by WhirlpoolTeam 5 years ago

  Helpful (0)Unhelpful (1)

  Report

  Sorry, there was a problem. Please try again later.