Customer Ratings & Reviews

My wife wanted a custom bathroom drawer storage setup - so with my Bambu Labs X1C and Gridfinity I was able to print a number of storage bins that fit the drawer perfectly. I needed ABS for the project as it is water resistant. It printed extremely well on my printer using the Generic ABS settings!

I've been a 3D Print professional for 10 years. I often test new filaments with the hope of finding something to add to our lineup. The spool of ABS Hyper that just tested was among the worst that I've ever tested. The tests were conducted on a calibrated Bambu P1S under ideal ambient conditions. I followed the range of recommended settings, including drying temp/time. I made 7 of our standard test prints. At best the surface quality was poor, even at reduced print speeds. Break tests: Lower end temps resulted in poor layer adheasion. Higher temps were still very weak. Unlike other ABS, the filament itself is soft, weak, and somewhat brittle. Testing ended when the nozzle clogged, causing the filament to crumble and jamb into the extruder gears. I had to dismantle the P1S restore the extruder module and replace the hot end assembly. We always print with reputable brand filaments. I've never experienced this level of failure. Maybe it was a bad spool (or section). I couldn't risk more down time to test the second spool. The two spools that we purchased were returned along with my review and samples of the print tests.

I've used Creality filiment for over a year now and it does a good job of bed adhesion without glue sticks or hair spray. But i do use a PEI printbed, or glass. I've had clogged nozzels with other brands ( .04 mostly .06 does better) but so far creality has worked on my ENDER 3 V3 KE.