Customer Ratings & Reviews

The case is very nice, I like the wood accents. It was a very easy case to assemble and came with a lot of good parts.

Nice wood finish. Came with 2 fans and every accessories.

Coming from a nzxt h6 and a meshify from years ago I had high expectations considering all the reviews were so positive. I tried to build it and got stuck at a few spots and didn't end up finishing. Some my fault some on the case. Pros: it looks like the photos. Very light. Reviews are overwhelmingly positive. Fans drawing air in from the mesh panel is a nice idea. (You will need to buy fans) Cons: felt light and cheap. Not all the seems like up. Front cover feels cheap like it could break any time. Opposite of my nzxt experiences. It comes with 3 front 140 fans only. And they aren't even that good. Even tho a lot of people use the liquid freezer 3 360 on this I don't recommend it. It will barely fit front mount and with the tubes down. You'll need longer radiator screws to use 140mm fans. The radiator will have to go on the inside of the bracket and the fans on the outside. There will be a gap. This is probably not an issue but not ideal. Even with 120 fans any stock radiator screw is going to feel a little short. I tried the lf3 front mount with a ASRock 7900xtx and it's too long. The lf3 radiator is about 5mm thicker than most and the Asus card is a little long. Also you have to angle the card it and it will be difficult to straighten with a front mount radiator. This case should be air cooler or 240mm AIO only. You will need at least 4 more fans. Or replace all. I would replace all since artic fans are so inexpensive. Cable management isn't great or even good at all. I didn't think nzxt was that good until I tried this case. There should be another set of ties down the middle of the for your GPU cable routing to the PSU and even fan routing. Maybe the thermals are great? And it makes up for all this.

This case is great, lots of airflow, the wood paneling and brass feet/buttons look cool and the inside is plenty big for all the parts. The only downside I found was my power supply was slightly too big which meant only one hdd fit properly but honestly that’s not that bad.

The case has a beautiful minimalistic design with brass accents that pop. The case was very easy to build in and has really nice features. The 240mm fans that come with the case are nice and quiet and the included disk drive dampers work really well and makes the spinning drive a lot quieter compared to my previous case. The included cable tidies are very concurrent and the cables for the buttons come cable managed. I only wish the case had a reset button at the top.

This case is fantastic and light weight. There are no glass panels to break. The top and side panels are perforated for air flow and are easy to remove. The wood accents on the front panel are classy. It comes in a high quality box with foam padding that you can ship anywhere. This is a great mid size case. Highly recommended.

The side mesh really is good for airflow. The case is well built and looks very nice. The wife really likes it. It can be tight to fit everything in if you have a big gpu like the xfx 7900xtx fits inside but it is tight with the side fan bracket that goes under where the side panel mesh is. But it does work. No real complaints when building in the case either. I would go with the XL if I was to buy again though as I worry with the way gpu sizes keep increasing that the case will need to be changed out when I get her a new gpu someday/upgrade the computer next as card length is pretty short for most of the big gpus.

Amazing case for the price. Great design if you aren’t looking to RGB all over the place and the air flow is fantastic. If you want a larger radiator on top, you’ll want to go with the XL. I have the Arctic Freezer III 240 on top and the fit with ram and the motherboard is very tight, on 2-3 mm clearance. Plenty of space for a large GPU however if you don’t do a front mounted radiator. Cable management is also a breeze with the available ports.

From the jump this case stood out to me because of the wood finish on the front. Upon getting the case. It seemed my parts wouldn’t fit. Graphics card and Cooler looked too big. I was ready to return it. Took a look closer, moved the fans around. Everything fit! Great surprise! Love the way it fits the desk esthetic! Will be getting one in the future should I need a bigger case!

I did a build with this case and I am very happy with the great cooling and the ample space to put in my components.

Well made and easy to use, while not looking out of place in a room

I really like this case. It was easy to install everything. It does fit a 4090 card, but it was a tight fit for the power cable as there was barely enough room since the power cord sticks out from the side of the 4090.

It was the easiest case I have ever built in and it had everything i needed in the case

The case looks great. The build quality is mostly great with the exception being the top panel. The top panel comes off with almost no effort which could be a problem if you try to pick it up.

Great case lots of room for fans only thing of note is that it does have a usb c port on it so if your motherboard doesn’t have a slot for it you won’t be able to use it

Love this case. The wood compliments my room perfectly and it has great airflow with the mesh side panel.

A great looking case for a reasonable price now i'm ready to upgrade the GPU

Love the case. Tons of great features, and they include a build guide to help newer PC builders with fan and radiator placement. Unfortunately, the massive silica gel packet that was included burst during transit, so thousands of tiny beads were loose inside the chassis. It took me over an hour to find them in all the nooks and crannies of the case, and I’m sure I missed a couple. This packet could’ve been secured somehow to avoid this.

Great case! Good looking, fantastic airflow, and easy to build in.

I moved my components from a prebuilt PC to this case, and it was an easy process! The case is big enough to make installation a breeze. The included fans are great and I decided to keep them in there