AudioControl - 2-Channel Active Line Output Converter with AccuBASS and Subwoofer Control - Black

Product Details: Active 2-channel bass restoration processor and line output converter. Designed to work with factory and aftermarket audio systems. Speaker-level inputs handle up to 30V (225 watts RMS). Low-level RCA inputs handle 150 mV - 2 Volts. RCA outputs Provides up to 9. 5 Volts of output. Adjustable Parametric Bass Controls. Adjust center-frequency and width of bass EQ processing. Auto turn-on via DC offset or Audio detection. Load selection switch (20, 60, or 20K ohm) to prevent factory stereo shut-down. 12 Volt turn-on output for aftermarket amplifiers. Selectable Ground Isolation switch to eliminate ground and alternator noise. Molex terminals for speaker signal and power. Wired remote bass level control included. LED Clip indicator. Total Harmonic Distortion: 0. 005%. Signal to Noise: >105 dB. Frequency Response: 10-20, 000 Hz. 1-year Manufacturer's Warranty.

Add an amplifier to nearly any radio with the KISLOC2 Stereo Line-Out Converter. Experience true sonic accuracy at any volume level with all the sparkling highs and thunderous lows of your original audio. KISLOC2 Stereo Line-Output Converter Unlike traditional LOCs the KISLOC2 is designed without inductors to deliver a completely flat frequency response at all volume levels. Using nothing more than your factory speaker wires the innovative KISLOC2 automatically converts the speaker signal into both an RCA signal and a powerful 100 milli-amp 12-volt remote wire using DC offset. Powerful enough to turn on multiple amplifiers the 12-volt remote wire delivers plenty of power without hunting for a switched 12-volt power source. Accepts up to 55 watts (16 volts) of input signal Fully compatible with standard radios and most smart radios* Delivers up to an 8-volt output signal Flat 20Hz-20kHz frequency range at all volume levels Includes a powerful 100 milli-amp remote turn-on wire. No 12V power source needed! LED indicator for DC offset turn-on *Amplifier output of smart radio must have 60 impedance or lower. What's in the Box 46KISLOC2 line output converter Owner's manual Specifications Accepts up to 55 watts (16 volts) of input signal Fully compatible with standard radios and most smart radios* Delivers up to an 8-volt output signal Flat 20Hz-20kHz frequency range at all volume levels Includes a powerful 100 milli-amp remote turn-on wire. No 12V power source needed! LED indicator for DC offset turn-on

Easily add an aftermarket amplifier to your vehicle’s factory audio system with the LocPRO 4-Channel Line Output Converter by PAC. The LP6-4 converts speaker-level (high-level) audio signals to RCA preamp (low-level) signals so you can install an aftermarket amplifier without replacing your factory radio. This four-channel line output converter can also be used to retain your vehicle’s OEM amplified audio system when replacing the factory radio.