Belkin - A3L791-07-PNK-S 7 ft. Cat 5E Pink Snagless Patch Cable CAT5e RJ-45M / RJ-45M

This Cat6 Ethernet Cable is an RJ45 male-to-male network patch cord for connecting computers and LAN devices to routers, modems, switches, hubs, patch panels, servers, printers, smart TVs, game consoles, NAS systems, and network media players. The cable supports bandwidth up to 550MHz and data rates up to 10Gbps on compatible Ethernet networks. Four unshielded twisted pairs help reduce crosstalk, while gold-plated 8P8C RJ45 contacts support stable signal transmission. Stranded copper-clad aluminum conductors, a flexible PVC jacket, molded strain relief, and snagless boots provide dependable everyday connectivity and help protect the retaining clips during installation. Technical Specifications:- Product Type: Cat6 Ethernet patch cable- Connector A: RJ45 male- Connector B: RJ45 male- Connector Type: 8P8C- Network Category: Cat6- Bandwidth: Up to 550MHz- Data Rate: Up to 10Gbps- Construction: UTP, 4 twisted pairs- Conductors: Stranded CCA- Connector Contacts: Gold-plated- Jacket: Flexible PVC- Boot: Molded snagless strain relief- Compatibility: Cat6, Cat5e and Cat5 networks- Standard: Meets or exceeds TIA/EIA-568-C.2- Warranty: Lifetime warranty Typical Applications: computer networking, router and modem connections, switches, hubs, servers, printers, gaming consoles, smart TVs, NAS devices, VoIP phones, network media players, patch panels, and office or home LAN setups

This Cat 6 shielded Ethernet patch cable - also sold as a Cat6 LAN cable, internet cable or RJ45 network cord - moves Gigabit traffic over a 24 AWG stranded bare copper core tested to 550 MHz, well beyond the 250 MHz the Cat 6 standard asks for. Foil shielding wraps all four twisted pairs, so the run stays clean beside power cabling, inside metal racks and near motors or ballasts where unshielded cords pick up noise. Each RJ45 plug carries 50-micron gold-plated contacts wired to T568B, and a snagless molded boot shields the locking tab so it does not snap when the cable is pulled back out of a packed patch panel. Backward compatible with Cat 5e and ready for Cat6a ports. Compatible with Cisco, Netgear, TP-Link, Ubiquiti, Linksys, ASUS, Synology and QNAP hardware. Stocked in 1, 2, 3, 5, 6, 7, 10ft, 14, 15, 20, 25, 50 and 100 ft - short jumpers through long Ethernet cables between rooms. Measure the path the cable travels, not the straight line. Best for: structured wiring, server rooms and patch panels. Not for: in-wall runs, outdoors, or 10 Gigabit across a full 100 m.

Wiring a crowded patch panel or switch where every millimetre counts? This Cable Leader non-booted Cat 5e Ethernet patch cable, also sold as a Cat5e LAN cable, internet cable or RJ45 network cord, drops the bulky boot so plugs sit side by side in high-density ports and air moves freely through the rack. It uses four twisted pairs of 24 AWG bare copper rated to 350 MHz, well above the 100 MHz the Cat 5e standard requires, with 50-micron gold-plated RJ45 contacts. Compatible with any RJ45 port on Cisco, Netgear, TP-Link, Ubiquiti, Linksys, ASUS, Synology and QNAP gear. Carries high speed Gigabit Ethernet up to 100 m and fits any Cat 5e, Cat 6 or Cat 6a jack, Cat6 and Cat6a patch panels alike. Stocked in 1 ft to 100 ft lengths, including 3, 10, 25 and 50 ft, from short patch cables to long Ethernet cables between rooms. Best for: patch panels, network switches, server racks and structured cabling. Not for: cables unplugged often (no latch protection), plenum or riser runs, or outdoor use.