Customer Ratings & Reviews

This is a well designed case. It comes with three preinstalled fans in the front. I highly recommend using the 3 fan single frames because they look so clean in the case (seams). Tons of room for a 3-slot gpu and a 360mm aio. A white atx mobo would be preferable, as there is alot of space to fill; cable managment gets a little more entailed w/ smaller boards. There is tons of room and fastener points in the back for painfree cable mgmt. Plentiful airflow from front/bottom to top/back. Oh, and toolless panels. It's a big case tho. There is some visibility on the psu, so either go w/ a white one or be prepared to paint/vinyl wrap/defend your choice of going w/ black. I utilized best buy's price match with microcenter to get a great deal on the case. Highly recommended case; no brainer when on sale, provided u have the room to place it somewhere prominent.

Very good price when on sale. This case replaced a Cooler master haf xm from 2012 ( I have been missing out all these years!) It is very spacious and luxurious. I installed a 240mm aio cooler with ease up top. There's much room for the cpu cables in the upper left corner for my atx mobo. My 3080ti fit well but was replaced with a 5070ti shortly after (length decreased a bit). The cable management is awesome and makes everything look tidy. The side mounted PSU is cool and gets it out of the way. Theirs a mobo cable bar that can be taken off if needed I had to in order to get the cables relaxed to fit. I did install an HDD in the back slot and an SSD. I used a corsair commander core and mounted it on the spot that was labeled controller. I took the 3 included case fans (which are silent even running at 1500rpms) and put them on the gpu intake. The case stays cool even about 10 degrees cooler than my old case. I also had 8 fans in my old case vs the 9 now. This new case is now a little taller but shorter than the previous one. I don't see much dust accumulation yet but only time will tell as other have mentioned the supposed intakes are filtered but without an actual filter.

This is a great case, plenty of space, great airflow. Amazing cable management. Looks nice. Stop thinking, this is your case.

Plenty of room, plenty of air flow, and it looks great.

I bought the NZXT Flow H7 case to build my new PC for 2025. Since I was going with an AMD Ryzen 9 9950X3D processor, which runs hot, I knew I wanted a case that could allow maximum fan placement and airflow. I went with this one because of the way the PSU can be mounted vertically and because of the countersunk fans on the bottom of the case. This results in a clean interior with a spacious vibe that allows air to flow more efficiently thanks to fewer obstructions. Normal cases have a floor at the bottom that houses the power supply, and it takes up so much space and inhibits airflow. But not this one. I also really appreciate the ease of cable management in the rear. With well-placed Velcro straps, you can route your cables where you want them and strap them into place so they don’t move around. There’s plenty of room in this case for the largest graphics cards in 2025. So rest easy. This is the case for me.

Have been looking for a case for months now, and had seen this one at a Best Buy outlet, airflow is tremendously amazing in this case, it’s a BIG case too so plenty of space for fans and a radiator, if you got a few hard drives and a full size motherboard or looking to have extra space for future reference, i recommend this one, or if you just want Amazing airflow, this is perfect with that as well

Better than the previous H7 Flow. Increased cable management, the removable panels are better, and the airflow is mostly better. A couple of notes: you will NEED 3x120mm bottom intake fans, or your case will look bad. It was designed in such a way that without intake fans, it's just like a big open abyss in the bottom and it looks bad. Overall, though, a good improvement in the H7 Flow design. ESPECIALLY with better cable management in the rear panel, and a better PSU placement that facilitates all the rest.

A well built case with plenty of space and excellent air flow! And space for large 3 fan cards

Great case with lots of room, one of the few cases that can take four total 2.5 inch SSDs anymore. Most cases nowadays only take 2. Has tons of spots for fans, is very easy to route cables, the cables for the USB Ports and Aux Port are nice and long. Also, nice that it has a mesh front panel instead of glass like a lot of cases.

A great case that can be upgraded to RGB if desired, you can tell that it is all designed for NZXT fans and gear, however 3rd party fans and gear works just fine. The case has great cable management and the clean look is a very nice touch. I love the case and the finishes.

Great case! Very high quality. It’s well designed (though I wish the IO was on the bottom. It already has a fan preinstalled, so that’s convenient. A bit disappointed that it doesn’t have an air filter, but that’s ok…

The front fans always suck up dust so it always looks dirty. the top doesn’t have a dust cover , and no rear fan . Which I went with RGB version. The black version is tinted the white is not. Overall at this price point I would recommend.

This case is amazing! Not only is it spacious, but it fits perfectly in my desk. I recommend! The airflow is also amazing!

Lots of room for fans and easy to build in. The removable panels help a lot when building. The fans underneath the GPU lowered temps by 10°C and made my PC run quieter.

This is good looking case can get it and at all point it is very good and no issues with it.

nice case, works well, looks neat, pretty cool case

Really spacious, makes building the pc very easy, and cable management is a breeze. It's really good for airflow. The included fans are pretty effective although they are easy to hear when running at full speed. I love that the panels are tool-less, so removing them to access the internal part is a breeze. The front I/O panel is located at the top, which is great for making this an underdesk/ floor PC tower. It is quite big though even though it's described as a mid-tower case. The only major caveat is the lack of dist filters. The product is marketed as having "super-fine" holes on the front and underside panels for intake, but they are not as effective as real, nylon dust filters. The case does require some serious care; things such as weekly wiping to remove the dust, or shooting compressed air to clear the internals from dust.

Great large size case with great airflow. The case allows plenty of airflow with the included fans on the bottom acting to help further keep the GPU cool. The instillation of so many fans is a mild hassle but one that is only required one time. The lack of a dust filter is a slight let down, though it is rather easy to purchase dust filters and with the case's design insert them hidden into the panel without disrupting the look. The case is rather large, so ensure you have plenty of room for it. Wires and components with the case are well organized and able to be kept hidden away behind the side panel.

Very nice case. Looks good and not gaudy. Some of the fan wiring was challenging, but in the end the case had plenty of spaces to make the cabling and wiring look great. I put the fans that came with case in the bottom and added some Thermalright argb fans for some subdued lighting. The case easily handled the 360mm Thermalright AIO. I am totally pleased with the looks and functionality of the finished product. I was most pleased with Bestbuy for having it in stock and delivering it in two days for free. I am a little less happy that it is now $10.00 cheaper. I recommend it and would buy it again.

Cable management and airflow are good, comes with 3 good fans