Whirlpool - 15.5" Pedestal for Front Load Washer and Dryer with Storage - White

The pedestal serves its purpose, but when you pair it with a washer, it vibrates and makes a lot of noise on the spin cycle. One flaw in the design is with the 2 metal bars that are used to hold/slide the bucket. These bars are not held in place very well. Towards the front, the bars are held in by a screw, which ensures a snug fit that won't move. Towards the back, it's basically resting on a metal slot. When the washer begins to vibrate, the back portion of these bars will vibrate and make a bunch of noise: you will definitely hear the metal clanking against itself. Additionally, the sheet metal on the outside of the pedestal has no supports to keep it from wobbling. Imagine hitting a large sheet of metal in the center and seeing how it wobbles, same thing here. My solution was to use some thick foam insulation to place some pressure between the bar and the metal siding. This prevents the bars from jostling around and the metal sheet from vibrating too much. This has helped a lot. See images attached of my solution.

Very nice item, raises the washer up to where it's easy to get clothes in and out, also good size storage drawer.

easy to operate Dryer controls. blankets Dryer Dried. Dryer sensor shuts down when load is dried. accessorie.

I replaced a 16 year old Whirlpool Duet set which had metal pedestals so these were disappointing. The back is open & these are fairly flimsy. They don't latch closed very well and only have one middle divider compared to the two the old ones had. They are basic and get the job done, but Whirlpool definitely went cheap on these.

Raises the washer and dryer to waistline level Easy to load and unload without stooping. Very sturdy. Stabilizes the washer and dryer. Excellent storage space below.